Hot Sale ???? 181101 Accel Brake Light Switch – Pressure Activated ????

8 reviews for Hot Sale ???? 181101 Accel Brake Light Switch – Pressure Activated ????

1. 

   Rated 5 out of 5

   LHFLA – July 8, 2016

   My T-bucket is light and requires very little brake pressure to bring it to a stop at low speeds. Most modern car brake light pressure switches would not make the brake lights come on unless you pressed hard on the pedal. The cure is this brake light switch designed for a Harley Davidson motorcycle. It operates as lower pressures and now I have brake lights at the touch of the pedal. If this would not have fixed the issue I was going to go with a mechanical switch. The only question in my mind is how long will this switch work. So far no issues, no leaks. To install just needed to change the terminals on the car to spade from round ones.

2. 

   Rated 5 out of 5

   hogger – August 4, 2018

   Arrived in less than 12 hours from when I ordered!Although the outside barrel is slightly larger than stock, the threaded part is the same on my Road King.First.. check if you have a wiring problem. Disconnect two wires, turn your key on, and jump those two wires with a paper clip. (Don’t bang into anything metal on the bike with the paper clip!)If your brake light illuminates, your problem is probably this switch.Next step. Buy one of these.Put it in. You will want to hold the back part of the mount with an open end 5/8 wrench while you use a socket with an extension to remove the old one, and install the new one (I used a 1″ socket with an extension.) Do not over tighten!! Pretend it’s a bleeder valve.. go easy on it. Not too tight. Just good and snug.Plug your wires back in.You should have happiness now.Highly recommend.

3. 

   Rated 4 out of 5

   BIG T – June 16, 2020

   This is the 3rd time I have had to replace my brake switch on my 09′ Fatboy in 5000 miles!First time using this brand of switch. Previous switches were a OEM Harley part (lasted 1000 miles).Second switch was a NAPA part (lasted 4000 miles). We’ll see how this one does.My fluid is Dot4 and non silicone based so it’s compatible with the switches I have used. This switch is larger in diameter than previous switches but fit fine.I’ll report back with any update.

4. 

   Rated 4 out of 5

   Amazon Customer – December 28, 2020

   Unfortunately this part is not correct for the motorcycle I ordered it for, the threaded shaft was too short and I had to order another brand.

5. 

   Rated 4 out of 5

   BVP – September 16, 2021

   product fit my 08 Streetglyde perfectly… larger than stock but still fit fine and the wire connections fit perfect… good price and quality out of box,, now to see how durability holds up !!

6. 

   Rated 5 out of 5

   Frequent Amazon buyer – January 26, 2022

   Nice product. Fit my Gasser hot rod build just as expected. I would recommend

7. 

   Rated 5 out of 5

   (Frank M Metallo – April 14, 2022

   Will not work if DOT 5 Fluid is being used

8. 

   Rated 4 out of 5

   Deven H – May 11, 2022

   Removed a heat shield to make easier to replace. Pretty straight forward, need to bleed again.