- Product Grade: Performance Part
- Brand: K&N
- Fit Type: Vehicle Specific Fit
- Item Dimensions LxWxH: 2.5 x 4.63 x 8.75 inches
- OEM Part Number: 995050
- CLEANS ALL OILED K&N AIR FILTERS
- RESTORES PERFORMANCE: Helps restore your filter to exceptional performance by removing filter-clogging build-up
- INCLUDES POWER KLEEN: A powerful, highly effective degreaser that quickly dissolves filter build-up and old oil, allowing filter grime to be rinsed away with water
- INCLUDES K&N RED FILTER OIL: K&N red filter oil remains suspended in the pleats of the cotton filter material of High-Flow Air Filters, allowing for exceptional contaminant capture
- CLEANING STEPS: Spray on Power Kleen, Rinse with water, Allow filter to dry, Apply fresh filter oil
- RENEWED EFFICIENCY: Restores air flow efficiency so your K&N air filter performs like new















Katy Rose P –
Easy to use for a diy-er who just encountered her first cold-air-intake oiled air filter. The dealership sold my used vehicle to me with a filthy filter – this only took a few minutes to use and (outside of air-drying time) was done in a snap!
JD –
Great kit, my filter wasnt that clogged but it had around 20.000 KM so i decided that was time for a clean, the process wasnt that bad, the slow part is wait for the filter to dry without any help (it was winter when i did the cleaning) but in around 2 days the filter was 100% dry.Is a process i can tolerate every few months or KM, I think the kit is good for 3 total cleaning if you are carefull with the application if not at least for 2 complete ones.
Matias –
Buen Kit de limpieza,funciona bien,talvez rebajar un poco el precio o dar mejores precios si compras mas de uno ayudaria.
Craig H. –
Great Quality and Works Amazing!!
“Paco Sanchez” –
Good product. Works well and is the safest to use on these filters cuz you know it isn’t going to damage them. Just seems pretty expensive for soap and oil. That’s the only reason I gave a 4.
Jerry Watson –
easy to use
M Allen –
Great product that cleans and recharges your K&N filter.One important tip (not mentioned in the documentation). Putting too much red oil on the clean filter will result in a fine mist of this oil being pulled into your intake tract and contaminating the MAF sensor when you rev the engine. At that point your car will run poorly.Solution? After you have put the oil on the pleats in the filter, place the filter on a triple folded kitchen paper towel so that the pleats just touch the towel and let the towel absorb the excess red oil. Leave it for about an hour and then put the filter back into the car. Clean your MAF sensor with a MAF cleaning spray and your car will run as new, without contamination.
Frankie –
First time using it and and very happy of the results. It makes my permanent K&N filter even better and save money in the long run. Recommended.