With the rear axle on top of the leaf spring, Belltech Lowering Blocks provide an inexpensive, easy to install way to lower your vehicle by increasing the distance between the leaf spring and the axle, effectively lowering the vehicle. Belltech lowering block kits are manufactured of high quality extruded aluminum and come complete with blocks, U-bolts, Nylon nuts and washers. The extruded aluminum process yields higher strength ratings when compared to cast or steel lowering blocks. Lowering blocks are designed to lower the rear of your vehicle in 1, 2, 3, or four inch increments. Also available with built in 2 degree taper for drive line angle correction.
- Fit Type: Vehicle Specific
- high quality truck and muscle car parts
- Also available with built in 2 degree taper for drive line angle correction
- Lowering blocks are designed to lower the rear of your vehicle in 1,2 or 3 inch increments







Amanda –
I used this kit on a 68 camaro for a temporary drop kit until I do a coilover conversion,( had to grind down the nipple on the blocks a bit and drill bigger holes in the factory bolt plates to make it work but they will work on 1st gen camaro’s )( on 1st gen camaro’s be sure to check your wheel backspacing before you do drop blocks on your leafs because you might have to run wheels spacers or install a shock relocation kit )with these 2″ blocks I had to run 1″ wheel spacers on my 18x10s because the shocks were touching my wheels after I lowered the car lol
Itsa Mea –
Exact fit for a 1994 Dodge Dakota SLT 2WD V8 for lowering the back end so it’s almost level now. The only thing is unbolting and flipping the centering bolt from the leaf pack may be a challenge. They should supply them in the kit but if you pick up a pair of 3/8″ new ones you’ll be prepared.
Jesse R. –
Received without the nuts or proper hardware. Block for the right side needs modified to fit properly. The hole in the block isn’t large enough and had to drill or grind it out. Otherwise ok and easy to install.
Robert Gutierrez –
Dimensions says 4 inches but these are TWO INCH blocks. Do not buy if you are looking for 4 inch blocks.
Brian –
Just what I needed
Daniel –
Todo bien, no es de instalación compleja, buen producto.
DAN C. –
Easy to install, put on a 2000 Blazer rear axle under a 1987 S10 frame.