New high quality aluminum die cast remote single ports up mount with 3/4 inch-16 filter threads and 1/2 inch NPT inlet and outlet ports allows for remounting filter for easy access to make messy filter changes under the vehicle a thing of the past. Temperature sender landing and dimple provided for an easy drill and tap installation. Comes with ultra bright polished finish. Filter mount uses Fram PH8A Oil Filter or equivalent.
- Allows oil filter to be remote mounted anywhere
- Cast from high quality aluminum
- Ultra bright finish
- 3 bolt heavy duty mounting plate













Amazon Customer –
Good deal but can present issues with mounting.
bob snow –
Dislikes, wish the threads that hold the filter on were permanently installed. Second it doesn’t tell you what filter it uses.Other than that it does what it suppose to do.
Big-T64 –
I was using this for a parts washer and really wanted a bigger filter but only the smaller filters fit it. Works good and was easy to put together but next time I will search out a larger one.
JM –
I used this to replace my passive oil filter on a 53 Power Wagon. Works as intended!
Donn grimes –
I bought the remote filter for my parts washer. I use a water based solvent -Oil Eater. The remote filter is excellent quality and easy to mount to whatever and works with out leaks or any other issues. My solvent was absolutely filthy so I ran it through the filter constantly to clean it up. I use a Wix filter with a synthetic filter media.
Chris –
I bought this to add a power steering pump filter and to add some additional volume to the system.It works very well. the barb fittings are for 1/2′ hose, i had to different barbs to use on 3/8 hose power steering return line. Overall its a nice setup but a bit pricey if you can’t use their barbs
KMF –
Perfect for my new parts washer