The starter cable plugs into the back of the CS or CTS monitor and channels through the fire wall. It acts as the primary communications cable between all of the EAS Components and the monitor. Use this cable to in conjunction with EAS turbo timers, Pressure sensors, EGT probes, and more.
- Easy installation
- Works with evolution CS or CTS
- Works with insight CS or CTS
- Easy installation
- Works with insight CS or CTS










Ryan B. –
This is necessary to add the EAS sensors to your system. I have the Trail Dash for my Jeep JK
tyson –
buy it you will need it for egt probe or other acc.
Linda Lou –
I enjoyed all 4 of the series..looking forward to your next “trial”
Albert Medrano –
It’s missing one pin. It’s just how it’s made, not an error.
Kirk –
Worked perfectly
Kittery –
Perfect replacement for my cts. I moved the monitor from the windshield suction cup mount to a pillar pod mount and I guess the original wire was fragile. It was 10 years old and split at the end where the wire goes into the connector. This replaced it and works as it should.
matt –
The end broke almost immediately. Super cheap plastic and super thin. Pretty sure the wire is cooper plated aluminum.
Amazon Customer –
Overpriced, good product. Need to make it with smaller ends to run through firewall.