- Brand: Spectre
- Material: Stainless,Stainless Steel,Rubber,Steel
- Color: White/Red/Blue
- Item Dimensions LxWxH: 1.9 x 1.2 x 1.1 inches
- Item Weight: 1.16 Pounds
- 4 foot long, can be easily cut to length
- Fits 5/8 inch fittings
- High-quality nitrile rubber hose
- Reinforced with a single ply of braided cord
- #304 grade stainless steel braid







Thomas P. Ament –
A little harder to work with then standard hoses. Make sure to wrap the hose with electrical tape where you want to cut it. Fibers like to poke you, too! Love the look!
74 Cuda –
poor product hose braiding has burrs sticking out so you cant run your hand down it with out poking your self poor quality fittings made in china junk
Amazon Customer –
These are nifty and I suppose mandatory for adding the wow factor to an engine compartment. The kit comes pre-cut and the ends sealed with black tape making it easy to install/remove the clamps. To shorten, the kit recommends a hacksaw; but I used a thin high speed metal cut-off abrasive disc. FOLLOW-UP: Was struggling until I realized the two halves are lightly pressed together… using a flat screwdriver can be pried apart (Aluminum easy to damage so use care). Pull back red cover up SST hose, place blue base (with loose clamp) over fitting install shielded hose then tighten clamp, slide red cover down and snap onto blue base.. .The SST hose clamps are cheap 6mm metric and strip easily. Did I miss this in the instructions? Autozone help line had no idea… GL
Bob –
Good quality
Robert M. –
Worked great. Plenty for the replacement of two separate hoses. Had to purchase more of the red/blue end caps.
jose castro nieves –
I used on my hot rod and its look real good.
Darrell Gibson –
Had one hose that was frayed wire’s, you got me this time…