Brand new ???? Spectre Performance 8711 Vacuum Sensor Adapter Kit ????

8 reviews for Brand new ???? Spectre Performance 8711 Vacuum Sensor Adapter Kit ????

1. 

   Rated 5 out of 5

   The Guy – September 12, 2015

   I ordered this because I have a 1993 Ford Probe 2.0 FSDE engine and all the intakes for this car have the wrong size pcv hose inlet. It has sooo many more parts than the pic shows it’s awesome. It came with the bit to cut the right size hole on my intake so I bought this and a new intake J pipe piece that had no inlets on it for a pcv or the iat sensor. Cut the holes in the right spots and inserted the grommets to fit my sensor and pcv hose boom! Works perfect. No leaks or any problems at all. Comes with enough pieces to do a few cars if they’re different sizes and if they ain’t, the least you’d have to do is get some rubber grommets and/or some plastic inlet pieces for the pcv hose but if you’re a car guy you already know this.

2. 

   Rated 5 out of 5

   Aviator – September 11, 2018

   I thought this had several sized grommets it seems its only two sizes. I should of researched it more. The kit looks ok, I wouldn’t use the hole saws on anything other than plastic or aluminum, anything harder would be iffy.Knocking off a star because the description lead me to think it had several sized grommets, but in reality it has 2 and different size “ports” that fit into one of the 2 sizes. I had hoped to use this to put an Intake Air Temp sensor into a cold air kit I put together for a swapped LS1…. Again none of the grommets is the right size for the IAT sensor on a 98-2002 Fbody based LS1 sensor.

3. 

   Rated 4 out of 5

   Anthony Romano – January 24, 2021

   It ended up working fine but I tried several minutes to align the bit with the hole saw and it just wasn’t built correctly to be centered. I used it anyway and while my hole probably wasn’t perfectly sized the grommet still sealed fine. I recommend using silicone spray to get the grommet in as it was pretty tough. Also, obvious but you need to file the burrs down on the hole as it wasn’t a super clean cut.

4. 

   Rated 5 out of 5

   Vitaliy – May 29, 2021

   The only thing that sucks about this is the drill bit everything else is not bad at all

5. 

   Rated 4 out of 5

   Antonio Jacome – June 9, 2021

   The grommets and fittings are great. The hole saw is garbage and unusable.

6. 

   Rated 4 out of 5

   Larry A. Scusa – November 25, 2021

   The provided hole saw worked perfectly in the aluminum air intake. Knocked off the burr and installed the grommet. The air temperature sensor fit snugly into the grommet.

7. 

   Rated 5 out of 5

   hector juarez – February 9, 2022

   Worked as it should but drill bit to cut holes is kinda janky and not the best quality. Grommets worked well for my needs and vaccume nipples are good too. For the price it’s not a bad deal for a kit to cut holes in your intake for iat sensors or vaccume lines.

8. 

   Rated 4 out of 5

   Cory Smith – November 29, 2022

   There are only 2 different grommet sizes. Neither of which fit a toyota air temp sensor. Very frustrating!