This lift plate bolts onto 2 BBI or 4 BBI intake manifolds and allows the engine to be lifted with an engine hoist. It provides a stable and easy lifting point and creates a seal over the intake for safe storage
- Bolts to 2 BBI or 4 BBI manifold
- Seals intake for safe storage
- Allows engine to be lifted with an engine hoist
- Mounts to intake manifold
- Gold Iridate plated for corrosion resistance








Tom –
I found there was no holes for my 70 lemans 2 barrel carb mount. Drilled them and it worked fine. My new Edlebrock Performer manifold fits perfect for it. Siggest buy it as its a good atrong plate but plan on drilling if needed
Scott R. –
This lifting plate easily handled the hoisting of my Ford 289 out of my 1965 Mustang fastback. It bolted up to my carburetor studs and did not show any signs of failing at all. During the entire operation it remained sturdy and surprisingly kept the load balanced. I would recommend this product.
BEAR –
Worked right out of box
Dave –
What can you say about an engine lift plate? Very sturdy construction and the way the holes are cut into the plate make it easy to attach to a variety of carburetors. I bought a couple so I can also use them to seal off the top of the carb when the engine is in partial rebuild stage.
Karl –
Works great
Amazon Customer –
For the money it feels sturdy, but I don’t fully trust the welds that are on it, so I’m taking it to a friend to have it welded better. I’d rather not drop an engine cause of something minor.
Kindle Customer –
Did the job with no issues. Very pleased.
Mathias –
Used this to install an engine into my 1968 Corvette and it held the engine and the transmission overnight with no problems. If you are worried that an aluminum intake manifold would be too soft of a metal to support it I can tell you I had a performer RPM from edelbrock and had no issues with holding the weight.