Budget ❤️ Uick Fuel Technology 30-803 Fuel Pressure Regulator ⭐

8 reviews for Budget ❤️ Uick Fuel Technology 30-803 Fuel Pressure Regulator ⭐

1. 

   Rated 5 out of 5

   Doc – January 21, 2013

   I installed an inline electric fuel pump and found it to be over pressurizing the carburetors.After this regulator was connected, just before the carbs, with the ignition key turned on, the fuel pump operating, it was so simple to adjust and the pressures delivered seemed accurate, and now my carburetors are as happy as I am!Making the connection with my fuel line was very simple too.Good quality for the price.

2. 

   Rated 5 out of 5

   evilokc – December 9, 2017

   showed up and worked fine. it already had a plug in one of the ports which is awesome. I bought one knowing I would need to block off one of the out holes. tip. mak sure to remove the plug they install and put some Teflon tape on it. its not sealed.

3. 

   Rated 4 out of 5

   Brad – December 7, 2019

   Used this for a motor swap I did , works well haven’t touched it since I plummed it in. If your using a carb and stock or electric fuel pump , use one of the outlets for a return back to the tank. Works great no issues.

4. 

   Rated 5 out of 5

   Kindle Customer – January 25, 2020

   Used it to stabilize the full pressure on my 85 F-150 300 straight 6. Edelbrock 500cfm Offy intake high flow exhaust HEI distributor conversion

5. 

   Rated 5 out of 5

   Tyson – February 17, 2020

   Just what I needed works fine.

6. 

   Rated 5 out of 5

   Greg C. – November 22, 2020

   good quality, better than the other units I have used in the past. not sure, but I think this unit is usa made

7. 

   Rated 5 out of 5

   Robby Williamson – March 20, 2021

   This regulator is nothing more than a t fitting with a bolt on top that gives you false hope. If it’s 10psi going in…then the psi going out will be less then half on both outlets which for a carburetor is not good. It’s mainly because it’s not a return type fuel regulator however what I did was simply restricting the flow of the return using a 1/4drive socket in line and it helped give me pressure back where it was needed….however at the end of it , the socket made all the regulator and I I simply have a cute looking t fitting on a bracket without the false hope screw….not trying to harp on it…in different application I bet it will work fine

8. 

   Rated 5 out of 5

   matt p – July 1, 2022

   Holds fuel pressure well at the 6 1/2 lbs that I want. Good quality. Easy install