Utility Jug Hose, Deluxe, Filler Hose, 14 in Long, Screw-On, Cap, Plastic / Vinyl, Clear / Black, VP Utility Jug Caps, Each
- Deluxe, 14-inch hose kit for VP Motorsport and VP Sportsman containers; Hose cap included
- Perfect for use with refueling in professional off-road and closed-course racing as well as for moving industrial oils and fluids
- Forms a water-tight seal with the rubber gasket that provides secure pouring and precise pouring for added convenience
- Perfect for use with refilling in professional off-road and closed-course racing, not for fuel used on highways; Not to be used with gasoline or street-legal fuels
- Get the most out of your Motorsport or Sportsman containers; Dimensions (L x W x H): 14.8 x 1 x 1 inches; Weight: 3.2 ounces








Jason Snyder –
The wide spouts on the VP square cans can make it hard to hit the mark without a funnel handy. This item takes care of that. Makes pouring from the square cans easy. Installation was a breeze, remove the plug in the standard VP cap, dab a little thread tape on the filler hose threads, thread into the cap, and tighten.
Tommy champeaux –
As advertised. Works great
Alexander Wessels –
Worked to replace my jug’s spout that had split where it threads in. Threads matched and this one is a bit more bendy (for now) works great. Only complaint is that the cap has an unnecessary number of threads and I have to unscrew it for like 20 seconds. Product is fine though.
DJ S. –
Used on existing fuel cans, all good just like new
Sparky of SoCal –
Product received as fast as expected. The little screen filter was a plus. It won’t stop anything much smaller than course sand but it’s more than any of my other nozzles. Hose attached with bands that won’t catch on things. If I need another I would get this again.
TENNESSEE –
Makes vp gas jugs pour without spilling. Easy to install and use.
Beldar –
My existing hose is all yellowed and stiff. This is new, clear, and flexible OEM product. Thanks!
David –
I have approximately eight of the vp racing jugs and every single one of them have the same terrible flaw and that is these hoses that they use are terrible even in warmest temperatures they don’t flex very well but they’re usable but in the fall and winter they’re worthless anytime I try and use them and try and bend the hose they crease and then snap off instead of the hose bending any other gas can I use that I’ve put the aftermarket easy flow or other replacements for these garbage EPA ones even in minus temperatures they still flex and bend and pour perfectly whereas these VP racing ones soon as it gets slightly cold they become stiff as a board and impossible to bend to get into gas tanks and in my case more than one have just snapped off where they tried to bend I regret buying any of the cans because they actually end up spilling more than me just using a midwest or other type of plastic can and replacing the EPA worthless nozzles with aftermarket ones I’m gonna sell all my VP racing fuel tanks to me they aren’t good at all and the hoses are the worst part.