Brand new ???? Yukon Gear & Axle (YPKD44-PC-T/L) TracLoc Clutch Kit For Dana 44/Chrysler 9.25 Differential ????

8 reviews for Brand new ???? Yukon Gear & Axle (YPKD44-PC-T/L) TracLoc Clutch Kit For Dana 44/Chrysler 9.25 Differential ????

1. 

   Rated 4 out of 5

   James – May 20, 2014

   These are a pain in the ass to put in but they were right ones. make sure you do your research before you pull one of these apart cause you will need a special tool to compress the spider gears and clutches in order to get the other spider gear shims in where they need to go. 100 miles so far and no problems yet….

2. 

   Rated 4 out of 5

   Rocket965 – November 7, 2015

   Ok I have over one thousand miles since I installed the kit. The thrust washers sent with the kit are tough to get in but worth it.

3. 

   Rated 4 out of 5

   Justin Barbeau – March 15, 2017

   From my experience, Yukon are some of the best components you can get for your axles. However, Kit does Not contain two side gears, two pinion gears, cross pin shaft, roll pin. This is for the clutch packs and retaining clips.

4. 

   Rated 4 out of 5

   ADV Rider – January 7, 2018

   Worked perfectly in my 2010 Ram 1500 with the 9.25 rear axle.

5. 

   Rated 5 out of 5

   David – April 1, 2018

   Looked everywhere trying to find this. Hard to come by. Exactly what I needed. Perfect fit.

6. 

   Rated 4 out of 5

   Derek – July 5, 2019

   Correct fit for 9.25 Chrysler rear end

7. 

   Rated 4 out of 5

   christina – October 26, 2019

   98 dodge ram is what i used it for

8. 

   Rated 4 out of 5

   David B. Knowlson – November 17, 2019

   product looked so good it could have been oe.