Wholesale ???? Yukon Gear & Axle (YSPABS-005) 108-Tooth ABS Tone Ring For Chrysler 9.25 Differential With 5-Lug Axle ????

8 reviews for Wholesale ???? Yukon Gear & Axle (YSPABS-005) 108-Tooth ABS Tone Ring For Chrysler 9.25 Differential With 5-Lug Axle ????

1. 

   Rated 5 out of 5

   William smith – February 9, 2015

   Perfect match

2. 

   Rated 5 out of 5

   Deacon Blues – July 31, 2015

   For months I had been dealing with the “ABS” and “Brake” warning light on my instrument panel… At first I thought “Oh, no big problem, just add some brake fluid….” the brake fluid was not low, then I thought the wheel speed sensor… I bought a new rear end speed sensor, replaced it… and I did not fix the problem, the “ABS” and “Brake” warning lights stayed on and my speedometer was not behaving correctly either… Then FINALLY, I understood that I needed a new “TONE RING” because the speed sensor was fine, did not need to be replaced, but the tone ring was bad. To replace the rear differential tone ring in a Dodge 9.25 rear end, you will NEED a “Differential Bearing Preload Wrench” (also available here at Amazon) to properly adjust the bearings on the left and right sides of the differential – this is critical and MUST be done properly and no other tool can substitute for it.

3. 

   Rated 5 out of 5

   Anon Omus – February 13, 2016

   Work as advertised.

4. 

   Rated 5 out of 5

   V. Hazera – September 20, 2018

   The perfect fit for my 2004 Dodge Ram 1500 5.7L Hemi. Very easy to install and you won’t need to apply any heat to it or to the carrier but you’ll need C-clamps, a brass mallet to tap it in and pliers.

5. 

   Rated 4 out of 5

   Gonzo – August 21, 2019

   Yukon stuff seems as good as factory !

6. 

   Rated 4 out of 5

   Christopher M. – December 11, 2019

   Was original Molar part. Good quality

7. 

   Rated 4 out of 5

   Michael Priest – March 20, 2020

   A++ Heat it up in the oven for 20 mins @ 350F and it drops on!

8. 

   Rated 5 out of 5

   Cooper Zirbel – April 19, 2022

   Rebuilt my axle with Eaton TruTrac and this gear fit perfectly on it!